Product Preparation & Application
Material Preparation:
Mix thoroughly before use. Reduction may be required for certain types of application. Water should be used for reduction, not to exceed 15% by volume. If a slower dry time is desired, use Butyl Carbitol.
Application:
A test panel for adhesion checks must be prepared if not using a Gemini manufactured stain. Temperature will effect viscosity. Titanium Waterborne coatings are designed for spray application. This product must not be polluted with oil, solvent based paint or the like and should not be applied to metal surfaces. Application and drying conditions must be at temperatures of 64?F or above and at a humidity of less than 65%. Increased air flow and/or drying temperatures, including the use of infrared lighting for cure will significantly decrease dry times. Further coats may be applied followed by sanding with 280/320-grit sandpaper. Maximum dry film thickness should not exceed 4 mils.
Clean-up:
Use water to clean all equipment when material is in a liquid stage. Use an 80/20 blend of water/Butyl Carbitol when material is partially cured. Use Acetone to remove dried coating.